Description
Genuine Electrolux inverter PCB board drive embraco, part number 140014525236, supplied for Electrolux & Westinghouse fridges and freezers. The same part is also catalogued as 140014525202. As a manufacturer-supplied part it fits exactly as the original did, with no modification.
About this PCB
The PCB (printed circuit board) is the control brain of the fridge. It reads the sensors, runs the program and switches the motor, heater, valves and pump on and off.
Signs it needs replacing
- No power, no lights or a display that stays blank
- Error codes that return after a reset
- A cycle that stops part way through, or functions that will not switch on
Key details
| Part number | 140014525236 |
|---|---|
| Alternative numbers | 140014525202 |
| Supersedes | 140014525202 |
| Brand | Electrolux & Westinghouse |
| Part type | Genuine manufacturer part |
| Appliance | Fridge |
| Category | PCB |
Suitable for
This inverter PCB board drive embraco is listed for the following Electrolux & Westinghouse models and other models in the same range:
EBE4507BC-L, EBE4507BC-R, EBE4507SC-L, EBE4507SC-R, EBE5307BC-L, EBE5307BC-R, EBE5307SC-L, EBE5307SC-R
Installation notes
Disconnect power and note where every plug goes before removing the old board. Many boards are supplied unprogrammed or need settings transferred, so check the notes below. Match the part number on your old part, or the model number on your appliance's rating plate, to the details above before ordering.
Frequently asked questions
Is 140014525236 a genuine Electrolux part?
Yes. This is the manufacturer's own part, not an aftermarket copy.
Which models does this inverter PCB board drive embraco fit?
It fits EBE4507BC-L, EBE4507BC-R, EBE4507SC-L and 5 other models listed above. Always confirm your model number first.
What part numbers does 140014525236 replace?
140014525236 can be used in place of 140014525202.
Do I need a technician to fit this part?
Many parts can be fitted by a competent DIYer with the power disconnected. Gas, refrigeration and sealed-system work must be done by a licensed tradesperson.