Description
Replacement 100C normally open 10Amp thermal control to fit Hisense appliances. Our part number is KSD301. Please note this is an aftermarket part, not manufactured by Hisense, built to the same function and fitting.
About this thermal
A thermal cut-out or thermal fuse is a safety device that cuts power if the appliance overheats. Once it has tripped or blown it usually has to be replaced.
When to replace it
- No heat but everything else works
- The appliance stops part way through a heating cycle
Part details
| Part number | KSD301 |
|---|---|
| Brand | Hisense |
| Part type | Aftermarket replacement part |
| Category | Thermal |
Additional details
- Widely used for temperature control or protection for household electric appliances.
- It is open until the surface reaches 100 Celsius degree, then the switch closes.
- General purpose, automatic reset, low cost, large capacity, minute current thermostats.
- Application: household electric appliances, PC, microwave ovens, irons, refrigerators, electronic oven, heating unit, coffeepot, water heater, and etc
Fitting and checking
Find and fix the cause of the overheating, such as a blocked vent or a faulty thermostat, before fitting the new cut-out. The model number is on the rating plate, usually inside the door or on the back panel. Compare it with the model list before you buy.
Frequently asked questions
Is KSD301 a genuine Hisense part?
No. KSD301 is an aftermarket part made to suit Hisense appliances. It is built to replace the original part and is sold as a non-genuine alternative.
Do I need a technician to fit this part?
Many parts can be fitted by a competent DIYer with the power disconnected. Gas, refrigeration and sealed-system work must be done by a licensed tradesperson.